...
- x: elbow2 0 + ElbowRadius
- y: elbow2 1
- z: elbow2 2
AutoCAD Grit Chamber Program
layer4 the "grit-pipe" layer is thawed
Rotate6
elbow3
elbow3 ~ origin~ = (pipe5 has not been created yet but see frontview picture in general section if not clear)
- x: pipe5 origin0
- y: pipe5 origin1
- z: pipe5 origin2 - ElbowRadius
AutoCAD Grit Chamber Program
Rotate7 the rotate3d function is used to rotate elbow1 \90 degrees about the z axis, with the above labeled rotation point as the pivot point. The resulting image is seen below on the left.
AutoCAD Grit Chamber Program AutoCAD Grit Chamber Program
Rotate8 the rotate3d function is used to rotate elbow1 -90 degrees about the x axis. The rotation point is the same as the one used in Rotate7. The resulting image is seen above on the right.
Rotate9