Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

To simulate the constraint of the side rails, set the X and Y components to Constant (0 m) and the Y component to Free.

Analysis Settings

The CubeSat must have its 1st resonant frequency above 100 Hz, as this frequency is the upper limit reached by many current launch vehicles.  The goal is to design a satellite which will not be shaken to pieces by reaching its resonant frequency during the launch phase.  Because of this limit we are only concerned with the first few resonant modes.

Under the Modal tab in the Outline window, left click Analysis Settings.  Set the Max Modes to Find to 3.  Select Limit Search to Range and click* Yes.  Leave *Range Minimum at 0 Hz and set Range Maximum to 1000 Hz.  These settings allow us to reduce run time by using some foresight as to what modal frequencies we expect to see and care about.

Go to Step 5 - Solution
Go to all ANSYS Learning Modules