...
Concept > Surfaces From Sketches.
Set the Base Object to Sketch 2 (located underneath XYPlane in the Tree). Then set Operation to Add Frozen as shown in the image below.
\
Then, click Generate
Carry Out Boolean
...
Operation
In this step, the inner circle will be subtracted from the outer circle in order to obtain the desired geometry.
Create > Boolean.
First, set Operation to Subtract. Next, use the face selection filter, , to apply the outer circle surface body as the Target Body. Then, use the face selection filter, , to apply the inner circle surface body as the Tool Body. Lastly, click Generate. At this point if you zoom into the center of the circle you should see the 1m diameter hole, as shown below.
Create a Bisecting Line
Click on XYPlane in the tree and it should highlight blue. Then, click the new sketch button, . In the new sketch draw a line on the y axis that goes through both of the concentric circles. Make sure that it is coincident to the y axis. Then trim the line segments that lay inside of the inner circle and the line segments that lay outside of the outer circle. This, is carried out by using the Trim feature located in the Modify portion of Sketching.
...