Experiment 2: Average Effluent Turbidity vs Velocity - High Floc Blanket Formation
During Experiment 1, the following capture velocities were used: 0.058 mm/s, 0.116 mm/s, 0.174 mm/s and 0.231 mm/s. This experiment was set on low floc blanket formation.
...
As expected, the effluent turbidity significantly higher than that of the control experiment. The presence of saturated water in the influent has a negative effect on the effluent turbidity. In order to quantitatively examine the performance of the experiment with saturated water, data from the control ramp experiment was referenced. The average turbidity for each flow rate tested was graphically compared to the control experiment. The standard deviations, graphed above, give a good idea of the breadth of the data. Comparing the two sets of data, the saturated water experiment had higher effluent turbidity in all cases than that of the control experiment. This data supports the perviously noted observation that the floc blanket appeared cloudy. The bubbles released as a result of a pressure drop in the system disturbed floc formation, allowing less floc particles to settle and more, smaller, lighter particles to leave with the effluent.
Experiment 2: Average Effluent Turbidity vs Velocity - High Floc Blanket Formation
During Experiment 2, the following velocities were used: 5 m/day, 10 m/day, 15 m/day and 20 m/day. This experiment was set on high floc blanket formation.
...