...
Our mesh is made out of a circular piece of plastic with the same diameter as the channel with lots of holes drilled into it. These holes are about 3/4 of a centimeter in diameter, so as to not break up the flocs that we formed. The whole purpose of this mesh is to assist the water to disperse evenly coming into the sedimentation channel.
For our tests, we have a digital camera set up that takes pictures of the floc blanket during formation. These pictures are taken every minute, allowing us to track the height of the floc blanket at any given time. We have tape on the sedimentation column that marks the height of the floc blanket to use as a reference.
This graph shows the height of the floc blanket in relation to the time the system has been on. There is a gap at the beginning of the data because there needs to be an initial accumulation of flocs in the column in order to form a blanket.
We noticed that the latter portion of the graph was portions of both graphs were linear, and created a trendline trendlines to give the data about the rate of formation. This would imply that in the presence of a mesh, about an hour and a half into formation, the floc blanket builds at a rate of about 0.3cm 30cm per minute, or 18.28cm per hour. It is hypothesized that during the initial hour and a half, the floc blanket is beginning to form and to compact upon itself, but only starts growing at a steady rate after this time has passed.
Without the Presence of a Mesh
This time, the experiment was run with the mesh removed, keeping everything else constant.
The slope of the trendline is different in this case. The floc blanket forms at a rate of 15.785cm per hour. This is slower than in the presence of a mesh, and therefore the full floc blanket takes When a mesh is not present, we saw the linear trend begin around two hours into the experiment, and the rate of formation was about 0.26cm per minute. The full floc blanket in this situation took about 4 hours to form, as opposed to 3.5 hours with a mesh.