Performance parameters analysis in 2D - preliminary simulation experiments

Objective

The effort began in Fall 2008 to try to characterize flocculation tank performance using parameters calculated from numerical solutions from CFD simulations containing all values at each node of the mesh. The following sets of experiments are carried out to confirm the previous results and provide an exploratory basis for further investigation of the relationship between the performance parameters and geometry of the flocculation tank.

Methods and Procedures

h/b ratios of 5, 10 and 20 were tested with 5 baffles. The completed test are summarized in the following table:

The series of geometries and meshes !preliminary simulations - completed tests summary.emf|height=300!
The geometry and mesh were created using the journal file "vary_flocculator_height, by varying the flocculator height". The boundary conditions and all the other FLUENT settings can be found in the report summary

...

Results

Since the finer mesh contains 1,500,000 cells, which is 50 times as many as that of the 2D mesh and 70 times as big as the 2D mesh in terms of the file size, the iteration takes about 30 seconds per step. After about 3000 iterations for 30 hours, the residual plots showed a promising tend to fall below a satisfactory level. (The simulations is still running at this moment)

...