...
- MathCAD Automated Materials List (Adela)
- Fixing Small MathCAD code issues (Adela & Reiko)
- Switch programs that refernce nominal diameters to calculate areas, hopper drain, width to depth ratio for sed drain. (Adela)
- Valve sizes: sludge drain, hopper drain?, floc drain (Adela)
- Flocculator design, after you figure out how many baffles that are ideal for a channel, figure out how many actually fit and put them in uniformly. (Reiko)
- Floc Drain Algorithm (Reiko)
- Sludge drain width needs to be adjusted (Reiko)
- Check needs to be added so that the length below the slope is at least 2.5cm
- Gap between slope plates and wall needs to be calculated (Reiko)
- Number of ports/plates in sed tank are underestimated overestimated (why?) The number of ports/plates were calculated based on the max sed length. Changed to be calculated based on the actual length now.
- Plates stay at 30cm
- Slope plate length need to be adjusted so the opposite corner rests against the wall (the length will decrease) (Reiko)
...