{float:left|border=2px solid black} [!sludgepipe with labels.bmp|width=550px!|AutoCAD Chemical Stock Tank Program] NorthEast Isometric View {float} |
layer6 - Layernew creates a new blue3 layer "sludgepipe."
layer <- layernew("sludgepipe",blue3)
{float:left|border=2px solid black} [!sludgepipe1.bmp|width=350px!|AutoCAD Chemical Stock Tank Program] Top View {float} |
sludgepipe1 - Calls the Sludge Pipe Program to create a sludge pipe.
sludgepipe1 <- Sludgepipe(wasteorigin,NDSedSludge,LSed,DSedSludgeOrifice/2,BSedSludgeOrifices,ENPipeSpec)
wasteorigin =
NDSedSludge - Sludge pipe diameter in sed tank.
LSed - Length of sed tank.
DSedSludgeOrifice - Diameter of orifices in sludge pipe.
BSedSludgeOrifices - Orifice spacing in sedimentation tank draining pipe.
ENPipeSpec - Enumerated type.
{float:left|border=2px solid black} [!rotate20.bmp|width=800px!|AutoCAD Chemical Stock Tank Program] Top View {float} |
rotate20 - Rotate3d turns the object based on a given axis and degree angle.
rotate20 <- rotate3d(p1,wasteorigin,"y",90)
Note: p1 is a dummy variable used only in the program help section to designate the matrix below.
p1 =
wasteorigin =
"y" - specifies axis that object will be rotated about.
90 - rotation angle
{float:left|border=2px solid black} [!rotate21.bmp|width=800px!|AutoCAD Chemical Stock Tank Program] Top View {float} |
{float:left|border=2px solid black} [!rotate21 rightview.bmp|width=350px!|AutoCAD Chemical Stock Tank Program] Right View {float} |
rotate21 - Rotate3d turns the object based on a given axis and degree angle.
rotate21 <- rotate3d(p1,wasteorigin,"x",90)
Note: p1 is a dummy variable used only in the program help section to designate the matrix below.
p1 =
wasteorigin =
"x" - specifies axis that object will be rotated about.
90 - rotation angle
layerset - Layerset selects the layer "0".
layerset <- layerset("0")
layerfreeze6 - Layerfreeze locks the layer "sludgepipe" so that it cannot be edited.
layerfreeze6 <- layerfreeze("sludgepipe")