Stepped Shaft in Axial Tension

Created using ANSYS AIM 18.1

Problem Description

This problem is taken from: Prantil, V. C., Papadopoulos, C. and Gessler, P. D., Lying by Approximation: The Truth About Finite Element Analysis, Morgan and Claypool (2013). Consider a stepped shaft under an applied axial load, P. A stress concentration is apparent at the step where the cross-sectional area is discontinuous. The cross section is circular.


So the problem becomes amenable, let’s consider a relatively small fillet placed at the step to reduce the stress concentration to a finite value.

The pressure load on the smaller cross-section is 1000 psi. Calculate the axial stress concentration factor and compare it to the formula provided in Roark’s Formulas for Stress and Strain, Warren C. Young and Richard G. Budynas, 2002.


Learning Goals

The purpose of this tutorial is to showcase the simplest stress concentration and demonstrate  that it can be resolved in 2 or 3 dimensions. Simple one-dimensional elements (i.e. simple axial bar elements) that capture constant stress within an element are insufficient to capture stress concentrations, even when many elements are used. That is to say, when the necessary physics is not contained in the element formulation, so-called h-convergence or using more elements captures “no more” of the solution than does a coars(er) discretization. This tutorial is meant to highlight where it is relatively straightforward to apply FEA and resolve a solution correctly that belies analytical treatment with uniaxial formulae (such as axial_stress = P/A).


A few words on the formatting on the following instructions:

  1. Notes that require you to perform an action are colored in blue

  2. General information will be colored in black, but do not require any action

  3. Words that are bolded are labels for items found in ANSYS AIM

  4. Most important notes are colored in red

 


Go to Step 1: Pre-Analysis & Start-Up

Go to all ANSYS AIM Learning Modules