Physics Setup

We need to assign this material from the material list to the model as shown in the following video. Otherwise, ANSYS will use the Young's modulus and Poisson's ratio for structural steel which is the default. This step is easy to overlook. Next, we apply the boundary conditions i.e. displacement constraints at the 3 left holes and traction on part of the right hole. Boundary surfaces where we neither apply a displacement constraint nor traction are assumed by ANSYS to be free surfaces with zero traction.

<iframe width="560" height="315" src="https://www.youtube.com/embed/pdXRYTnQdYE?rel=0" frameborder="0" allowfullscreen></iframe>

Summary of steps in above video:

Change the material from default to a newly created material
Change the properties of the new material to those of Al 6061-T6 in the problem description
Create a fixed support at the three holds
Create a force acting on the inside facing circular hole
Specify the y-component to be 100lbf

Under Construction

Go to Step 5: Numerical Solution

Go to all (ANSYS or FLUENT) Learning Modules