|
This page goes through the post-processing steps for the Supersonic Flow Over a Wedge in the CFD Post post-processor included with ANSYS Workbench. For instructions on performing the post-processing using the classic FLUENT post-processor, see this page. |
The following video shows how to make a plot of the Mach number contours using CFD Post. If the videos below don't appear in your browser, try reloading the webpage
<iframe width="600" height="338" src="//www.youtube.com/embed/cZpjpNbxXYM" frameborder="0" allowfullscreen></iframe> |
The following video shows how to make a plot of the pressure contours.
<iframe width="600" height="338" src="//www.youtube.com/embed/uPfpFds_JpQ" frameborder="0" allowfullscreen></iframe></iframe> |
To plot the velocity vectors, follow the steps in the video below.
<iframe width="600" height="450" src="//www.youtube.com/embed/sTm_G4W7ujQ" frameborder="0" allowfullscreen></iframe> |
First, we'll create a line at y=0.4m. Then, we'll plot the Mach number variation along this line using the "Chart" facility in CFD Post. These steps are shown in the video below.
<iframe width="600" height="338" src="//www.youtube.com/embed/tJMbrxn7Jzw" frameborder="0" allowfullscreen></iframe> |
Go to Step 7: Verification & Validation
Go to all FLUENT Learning Modules