Author: John Singleton, Cornell University

Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification and Validation
Exercises

5. Solution

Specify Results (Deformation)

Here, we will tell ANSYS to find the deformation for the first six modes. Then, we will be able to see the shapes of the six modes. Additionally, we will be able to watch nice animations of the six modes.

In order to request the deformation results (right click) Solution > Insert > Deformation > Total as shown below. 


https://confluence.cornell.edu/download/attachments/145756998/InsertDef_Full.png


Then, rename "Total Deformation" to "Total Deformation Mode 1" ((right click) Total Deformation > Rename)

Run Calculation

In order to run the simulation and calculate the specified outputs, click the Solve button, .

Save



Go to Step 6: Results

See and rate the complete Learning Module

Go to all ANSYS Learning Modules