Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 27 Current »

Cantilever Beam

Created using ANSYS 17.1

Problem Specification

Consider the beam in the figure below.  It is clamped on the left side and has a point force of 8kN acting downward on the right end of the beam. The beam has a length of 4 meters, width of 0.346 meters and height of 0.346 meters (cross-section is a square). Additionally, the beam is composed of a material which has a Young's Modulus of 2.8x10^10 Pa. Using ANSYS, calculate the following:

1. Deformation of the beam
2. Maximum bending stress along the beam
3. Bending moment along the beam



Go to Step 1: Pre-Analysis & Start-Up

Go to all ANSYS Learning Modules

  • No labels