You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 23 Next »

Unable to render {include} The included page could not be found.
Unable to render {include} The included page could not be found.

Cantilever Beam

Created using ANSYS 13.0

Problem Specification

Consider the beam in the figure below.  It is clamped on the left side and has a point force of 8kN acting downward on the right end of the beam. The beam has a length of 4 meters, width of 0.346 meters and height of 0.346 meters (cross-section is a square). Additionally, the beam is composed of a special material called Cornellium which has a Young's Modulus of 2.8x10^10 Pa. Using ANSYS, calculate the following:

1. Deformation of the beam
2. Maximum bending stress along the beam
3. Bending moment along the beam



Go to Step 1: Pre-Analysis & Start-Up

Go to all ANSYS Learning Modules

  • No labels