You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Next »

FLUENT - Flat Plate Boundary Layer Step 4

Useful Information

Click here for the FLUENT 6.3.26 version.

Step 4: Setup (Physics)

If you have skipped the previous mesh generation steps 1-3, you can download the mesh by right-clicking on this link. Save the file as plateBL.msh.

Launch FLUENT

Lab Apps > FLUENT 6.3.26

Select 2D under Dimension in the FLUENT Launcher window and click OK.

Import File

Main Menu > File > Read > Mesh...

Navigate to your working directory and select the plateBL.msh file. Click OK.

Check that the displayed information is consistent with our expectations.

Analyze Mesh

First, we check the Mesh to make sure that there are no errors.

Problem Setup > General > Mesh > Check

Any errors in the Mesh would be reported at this time. Check the output and make sure that there are no errors reported.

Mesh > Info > Size

How many cells and nodes does the Mesh have? You can check this in the graphics window where the mesh should be displayed. If it is not, you can display the mesh by going to

Problem Setup > General > Mesh > Display

Define Properties

We will now define the models that are going to be used by the model. This are located under Problem Setup > Models

Problem Setup > Models > Energy

Use the default and click OK.

Problem Setup > Models > Viscous

Select Laminar under Model and click Edit.


 
We want to leave the default value so you can click Cancel.

Problem Setup > Materials

Double click air or select it and click Create/Edit. Make sure air is selected under Fluid Materials. Set Density to 1.00 and Viscosity to 1e-4 so that we can get Re of 1e4.


Higher Resolution Image
Click Change/Create.

Define Boundary conditions

Problem Setup > Boundary Conditions

Set the inlet boundary type to velocity-inlet. Then click Set...Set the velocity magnitude to 1 m/s. Set the outlet type to pressure-outlet boundary. Use gauge pressure of 0 Pa.Use the default value of wall for the plate. Set the top to symmetry boundary type. Symmetry boundary condition means that the component normal to the wall is zero.

Problem Setup > Boundary Conditions

 > Operating Conditions


 
Use the default value. Click OK.

Go to Step 5: Solution

  • No labels