Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3
Include Page
SIMULATION: ANSYS 12 - Beam Tensile Bar (Results-Interpretation) - PanelSIMULATION: ANSYS 12 - Beam
Tensile Bar (Results-Interpretation) - Panel

...

titleUnder Construction

...

Include Page
ANSYS Google Analytics
ANSYS Google Analytics

Tensile Bar (Results-Interpretation)

Created using ANSYS 13.0

Learning Goal

This ANSYS tutorial focuses on the interpretation and verification of FEA results (rather than on obtaining an FEA solution from scratch). The ANSYS solution files are provided as a download. We read the solution into ANSYS Mechanical and then move directly to reviewing the results critically. We are particularly interested in the comparison of FEA results with hand calculations. The objective is to help you learn the process of interpreting FEA results critically. There are other tutorials to help you learn the process of developing an ANSYS solution from scratch.

Problem Specification

A steel bar is mounted in a rigid wall and axially loaded at the end by a force P = 20kN2 kN as shown in the figure below. The bar dimensions are indicated in the figure. The bar thickness is t=10mmis so thin that there is no significant stress variation through the thickness. Neglect gravity.


Image Modified

The material properties are:

  • Young's modulus E = 200 GPa
  • Poisson ratio = 0.3

In this exercise, you are presented with the numerical solution to the above problem obtained using from finite-element analysis (FEA) . This solution has been obtained using ANSYS software. Compare the FEA results for the stress distribution presented to you with the corresponding analytical solution. Justify agreements and discrepancies between the two approaches (FEA vs. Analytical).

Go to Step 1: Pre-Analysis & Start-Up
See and rate the complete Learning Module

Go to all ANSYS Learning Modules