SimCafe

Space shortcuts

Child pages
  • ANSYS - Plate with a hole - Problem Specification

Versions Compared

Old Version 61

changes.mady.by.user user-0108f

Saved on

compared with

New Version 62

changes.mady.by.user user-0108f

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel
Wiki Markup
{alias:plate} {panel}

Author:

Rajesh

Bhaskaran,

Cornell

University {color:#ff0000}{*}Problem Specification{*}{color}\\ [1.

University

Problem Specification
1. Start-up

and

preliminary

set-up

|ANSYS - Plate with a Hole - Step 1]\\ [


2.

Specify

element

type

and

constants|ANSYS - Plate with a Hole - Step 2]\\ [3. Specify material properties |ANSYS - Plate with a Hole - Step 3]\\ [4. Specify geometry |ANSYS - Plate with a Hole - Step 4]\\ [5. Mesh geometry|ANSYS - Plate with a Hole - Step 5]\\ [6. Specify boundary conditions |ANSYS - Plate with a Hole - Step 6]\\ [7. Solve|ANSYS - Plate with a Hole - Step 7]\\ [8. Postprocess the results|ANSYS - Plate with a Hole - Step 8]\\ [9. Validate the results|ANSYS - Plate with a Hole - Step 9]\\ [Problem Set 1|ANSYS - Plate with a Hole - Problem Set 1] {panel} h2. Problem Specification Consider the square plate of uniform thickness with a circular hole with dimensions shown in the figure below. The thickness of the plate is 1 mm. The Young's modulus _E_ =10{^}7^ MPa and the Poisson ratio is 0.3. A uniform pressure _p_=1 MPa acts on the boundary of the hole. Assume that plane stress conditions prevail. Determine the displacement and stress fields using ANSYS. This problem is taken from section 6.14, p. 240-244 of [Cook et al|ANSYS - Plate with a Hole - Step 9 #ref]\\ !Plate.jpg! *[*Go to Step 1: Start-up and preliminary set-up*|ANSYS - Plate with a Hole - Step 1]* [See and rate the complete Learning Module|ANSYS - Plate with a hole (old version)] [Go to all ANSYS Learning Modules|ANSYS Learning Modules]

constants
3. Specify material properties
4. Specify geometry
5. Mesh geometry
6. Specify boundary conditions
7. Solve
8. Postprocess the results
9. Validate the results
Problem Set 1

Problem Specification

Consider the square plate of uniform thickness with a circular hole with dimensions shown in the figure below. The thickness of the plate is 1 mm. The Young's modulus E =107 MPa and the Poisson ratio is 0.3. A uniform pressure p=1 MPa acts on the boundary of the hole. Assume that plane stress conditions prevail. Determine the displacement and stress fields using ANSYS. This problem is taken from section 6.14, p. 240-244 of Cook et al

Image Added

Go to Step 1: Start-up and preliminary set-up

See and rate the complete Learning Module

Go to all ANSYS Learning Modules